10/5/2020 In-sink-erator Ss100 User Manual
Mounting Adaptor
Selection Guide
This manual also for: Ss-75, Ss-100, Ss-125, Ss-150, Ss-200, Ss-300, Ss-500, Ss-750, Ss-1000. Please, tick the box below to get your link: Print manual. Manualslib has more than 281 InSinkErator manuals Checkout popular InSinkErator categories Garbage Disposal Manuals; Water Dispenser Manuals; Dispenser Manuals.
for Foodservice Food
Waste Disposers
m
s
ent.
Use This Chart to Select the Right InSinkErator Mounting Adaptor
A.Disconnect existing disposer from sink bowl or cone.
B.Find the diagram that matches your sink bowl or cone.
C.Measure the A and B dimensions (also C, D and E if indicated).
D. Match the manufacturer and dimensions to find the adaptor number to order.
FLANGE SINK MOUNT
AB
A – Diameter (sink or bowl opening) B – Diameter (outside flange)
2
AEB
A – Diameter (sink or bowl opening) B – Diameter (outside flange)
E – Diameter (bolt hole circle)
Special Information
Loose ring on sink not used with this adaptor (O.D. of loose ring is 7½' with six bolts – 7' bolt hole circle diameter).
A – Diameter (sink or bowl opening) B – Diameter (outside flange)
4 C
A – Diameter (sink or bowl opening) C – Diameter (inside bend)
5 C
MEASURE
FROM ABOVE (INSIDE BEND)
AE
In Sink Erator Manual
A – Diameter (sink or bowl opening) C – Diameter (inside bend)
E – Diameter (bolt hole circle)
6 C
MEASURE FROM ABOVE
(INSIDE BEND) SNAP-
RING A GROOVE
A – Diameter (sink or bowl opening) C – Diameter (inside bend)
7
D
NO FLANGE MOUNT
A
A – Diameter (sink or bowl opening) D – Diameter
8
A
Special Information
Discard previous adaptor parts (clamping ring supplied).
Discard previous adaptor parts – has snap ring groove on outside of sink throat.
Special Information
4¾' rubber connection sleeve and clamping bands. Support legs required.
6¼' rubber connection sleeve and clamping bands. Support legs required.
7¼' rubber connection sleeve and clamping bands. Support legs required.
Ise In Sink Erator
8¼' rubber connection sleeve and clamping bands. Support legs required.
Every InSinkErator disposer reflects an uncompromising commitment to quality as well as state-of-the-art engineering.
![]()
Unlike other manufacturers, we begin with the raw materials and build virtually every component that goes into our disposers.
It’s all part of our demanding quality control programs that cover not only the initial design, but every step in the manufacturing process.
Whether you serve 25 or 2500 people, there’s an InSinkErator disposer that’s right for you.
Recommended Sizing Chart*
2500-over Contact your Food Service Consultant or InSinkErator
For special applications, such as supermarkets or other heavy, continuous volume installations, select Models SS-750 or SS-1000
* The models listed are the minimum size InSinkErator disposer to be used at the point-of-origin for food wastes. Sizing recommendations are given in general terms. Actual capacities vary depending on the type of food waste.
10 Stainless Steel Models from ½ H.P. to 10 H.P. in three basic sizes.
To continue the download you need to go through the captcha:
In Sink Erator Troubleshooting![]() Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |